Date of Award
8-2023
Document Type
Thesis
Degree Name
Master of Agriculture (MAgr)
Committee Chair/Advisor
Dr. Joe Mari Maja
Committee Member
Dr. Gilbert Miller
Committee Member
Dr. Michael Marshall
Committee Member
Dr. Matthew A Cutulle
Committee Member
Dr. Jun Luo
Abstract
Chemical spraying is one of the most important and frequently performed intercultural agriculture operations. It is imperative to utilize appropriate spraying technology as a selection of ineffective one leads to waste of agrochemicals to the non‐target area. Several precision technologies have been developed in the past few decades, such as image processing based on real‐time variable‐rate chemical spraying systems, autonomous chemical sprayers using machine vision and nozzle control, and use of unmanned aerial and ground vehicles. Cotton (Gossypium hirsutum L.) is an important industrial crop. It is a perennial crop with indeterminate growth habit; however, in most parts of the United States, it is grown as an annual crop and managed using growth regulators. Cotton defoliation is a natural physiological phenomenon, but untimely and/or inadequate defoliation by natural processes necessitates the application of chemical defoliants for efficient harvest. Defoliation is a major production practice influencing harvester efficiency, fiber trash content, cotton yield, and fiber quality. Currently, defoliant spraying is done by conventional ground driven boom sprayer or aerial applicator and both systems spray chemical vertically downwards into the canopy, which results in less chemical reaching the bottom of the canopy. Thus, a new autonomous ground sprayer was developed using robotics and pulse width modulation, which travels between two rows covering the whole canopy of the plant. Field research was conducted to evaluate the (i) effect of duty cycles (20%,40%, and 60%) on droplet characteristic (droplet distribution, deposition, and drift potential), defoliation cotton fiber and (ii) effect of duty cycles on cotton yield and
II
fiber quality. Droplet characteristics (droplet distribution, density, and potential droplet drift) were non-significant across the treatments and results from the water‐sensitive paper field test showed adequate penetration with low flow rates. Therefore, a 20% duty cycle was sufficient to defoliate based on the result of the field experiment. Likewise, the defoliants could be applied safely at the duty cycles tested without influencing fiber quality except for nep/gm, length (Ln), L (5%), short fiber content (SFCn), trash content in field 1 and micronaire, nep size, length (Ln), span length (5%), SFC, and fiber fineness in field 2 which were significant. However, the 20% duty cycle significantly reduced the amount of defoliant and would be a good choice for the autonomous cotton defoliation. This is a significant development as there is a huge potential to save on the cost of applying defoliant chemicals and the environment.
Recommended Citation
Neupane, Jyoti, "Development of New Cotton Defoliation Sprayer Using Unmanned Ground Vehicle and Pulse Width Modulation Technology" (2023). All Theses. 4084.
https://open.clemson.edu/all_theses/4084