Date of Award

12-2008

Document Type

Thesis

Degree Name

Master of Science (MS)

Legacy Department

Mechanical Engineering

Committee Chair/Advisor

Thompson, Lonny L

Committee Member

Joseph , Paul F

Committee Member

Li , Gang

Abstract

The acoustic signature and noise produced by non-pnuematic wheels such as the Michelin TWEELTM is a critical design criteria for automotive and other mobility applications. The TWEELTM structure consists of three basic parts: (1) a circular deformable 'shear beam', (2) collapsible spokes and (3) a rigid hub. During high speed rolling the TWEELTM produces acoustic noise which is hypothesized to be due to resonant vibration of the TWEELTM spokes as they enter the contact region, buckle and then snap back into a state of tension. In order to identify and help understand the causes of acoustic noise for a rolling TWEELTMa nonlinear two-dimensional finite element model using ABAQUS has recently been developed by a research team at Clemson and Michelin. The TWEELTM model consists of a shear beam modeled as two inextensible membranes with high circumferential modulus separated by a relatively low modulus elastic material. The temporal variation in spoke length as the spoke passes through the contact zone is extracted and used as input to a 3-D model of a single spoke. The 3-D spoke model is able to capture more complex vibration modes of the spoke, including out-of-plane 'flapping' behavior that are thought to be a primary source of acoustic excitation. The original model studied changes in uniform spoke thickness and wheel rolling speeds on amplitude and frequency of spoke vibrations.
The TWEELTM model used in this work is a continuation and expansion of this model; additional geometric parameters of the spokes are examined including edge scalloping, reduced width with scalloping, curvature change, and variable thickness. In addition, modal frequencies and shapes of the various spoke design strategies are computed and correlated with the frequency response of the out-of-plane spoke vibrations. Results indicate that scalloping the edges of the spoke can dramatically reduce the amplitude of vibration, but do not have a strong effect on frequency peaks. An optimal amount of scalloping was determined which reduces maximum vibration amplitude to an asymptotic value. Changes in spoke thickness do not significantly affect the frequency, but can affect the amplitude of vibration. Changes in spoke width do not appear to affect either frequency or amplitude significantly. Spokes with smaller curvature resulted in a load-displacement curve which indicates higher wheel stiffness and produced higher vibration frequencies but with lower amplitude when compared to spokes with bigger curvature.
In previous models, the dynamic loading and rolling steps where performed using ABAQUS/Explicit with a restart from a steady-state cooling analysis performed in ABAQUS/Standard. In this work, additional models are developed and compared where the dynamic loading and rolling steps are performed with restart from a transient cooling analysis using ABAQUS/Explicit and an analysis with no cooling step but an initial defined pre-tension. Results obtained from these alternative methods for modeling pre-tension produced a spoke-length profile with reduced amplitude high-frequency oscillations.

Share

COinS
 
 

To view the content in your browser, please download Adobe Reader or, alternately,
you may Download the file to your hard drive.

NOTE: The latest versions of Adobe Reader do not support viewing PDF files within Firefox on Mac OS and if you are using a modern (Intel) Mac, there is no official plugin for viewing PDF files within the browser window.